Help you find the for this specific version.
Power cycle the AP while holding the MODE button until the light turns solid red/amber, then release. Load the Image (via Console):
show version : Confirms the current boot image reads 15.3(3)JPO to ensure the correct patch level applied successfully.
Downloading enterprise Cisco software images requires caution. Cisco locks these specialized operational binaries behind an entitlement system. Ap3g3-k9w8-tar.153-3.jpo.tar
is the official Cisco Systems network operating system image designed to run lightweight Control and Provisioning of Wireless Access Points (CAPWAP) software on Cisco Aironet 2800 and 3800 Series enterprise access points .
to convert from lightweight (controller-based) to autonomous mode.
Once logged in, use the archive download-sw command to install the new software: Help you find the for this specific version
When operating with the ap3g3-k9w8-tar.153-3.jpo.tar image, the Aironet 2600 AP Go to product viewer dialog for this item. offers several key technologies:
If an access point is stuck or needs a manual update, you can use the following command from the AP's CLI to download and install the software:
To install this specific file on a Cisco AP, you typically use the following command in the privileged EXEC mode: archive download-sw /overwrite /reload tftp://[Your_TFTP_Server_IP]/ap3g3-k9w8-tar.153-3.jpo.tar Ap3g3-k9w8-tar.153-3.jpo.tar
AP3802i wont join 5508 controller - Page 2 - Cisco Community
Connect an Ethernet cable directly from your workstation's network interface card to the primary LAN/PoE port of the access point.