Use your soldering iron to heat and remove the remaining leg stubs. :

Solder the Standby trigger wire to its required power/ground state to force the amplifier to remain permanently awake.

Replacing the volume control on your Creative Gigaworks T3 is a relatively straightforward process that can be done with some basic tools and technical know-how. By following the steps outlined in this article, you should be able to successfully replace the volume control and get your T3 working smoothly again.

Original Creative replacement pods are rare. Alternatives include:

Troubleshooting and Replacing the Volume Control Dial on Creative GigaWorks T3 Speakers

The large black knob is not simply pulled off. It is secured to the potentiometer shaft with glue or double-sided tape. Grip the knob and pull upward firmly . You may feel resistance as the adhesive breaks. Don't worry—this is normal.

entirely by shorting the internal wires, though this forces you to control volume via your computer or audio source Step-by-Step Replacement Guide

Remove the screws and carefully separate the plastic housing. Take care not to tear the thin ribbon cables or wires inside.