V2ray: Mikrotik

You must prepare a valid config.json file for your V2Ray server and ensure it is placed on the router's storage. 5. Routing Client Traffic (Mangle & Routing Table)

This command sets the container's Docker registry URL and a temporary directory for pulling images.

:

: Ensure that the V2Ray gateway machine itself is not included in the Proxy_Devices firewall address list. If it is, it will attempt to route its own encrypted outbound traffic back into itself, causing an immediate crash.

Verify that the 172.17.0.2 (container IP) is accessible from the router ( /ping 172.17.0.2 ). v2ray mikrotik

Running V2Ray at the router level offers several key advantages:

Here’s a technical write-up on using with MikroTik (RouterOS). This covers the common use case: V2Ray client on a MikroTik router to route traffic through a V2Ray server (VMess/VLess). You must prepare a valid config

Once the container is running (it should show running status), you need to route traffic to it. 1. Create a Routing Table /routing/table/add name=v2ray-table fib Use code with caution. 2. Configure Firewall Rules (Mangle)

: Use a pre-built image such as teddysun/v2ray . Users on the MikroTik Forum have documented success using these images to run Xray/V2Ray clients. : : Ensure that the V2Ray gateway machine

Create a veth (virtual ethernet) interface and a bridge to allow the container to communicate with the RouterOS environment.

/system/package/print # Ensure container is enabled. If not, install and reboot. /system/device-mode/update container=yes Use code with caution.